- Shut off the pump to the pool.
- Use a brush to scrub the algae and dirt off of the steps.
- Rinse the steps off with a hose.
- Mix together a solution of 1 part bleach to 10 parts water.
- Pour the solution over the steps and let it sit for 15 minutes.
- Rinse the steps off with a hose.
- Turn the pump back on.
CONTENTS
Ask the Pool Guy Mark Q&A: Vinyl Steps are Slippery? 5 Tips to Reduce Slippery Steps
H2O Non Slip Tread Installation in a Pool
What can I use on slippery pool steps?
There are a few things you can do to make slippery pool steps more safe. One is to apply a non-slip coating to the steps. This can be done with a brush-on product or a spray-on product. Another is to place non-slip mats on the top and bottom of the steps. You can also use tape to create a non-slip surface on the steps.
How do I make my pool floor less slippery?
There are a few things you can do to make your pool floor less slippery. You can add a textured surface to the floor, which will provide more traction for your feet. You can also add a non-slip additive to the floor of the pool, which will create a rougher surface that is less likely to be slippery. Finally, you can increase the pH of the pool water, which will make the surface of the pool less alkaline and therefore less slippery.
Are fiberglass pool steps slippery?
Fiberglass pool steps are not usually slippery, but they can be if they are not maintaine properly. Chlorine and other chemicals can break down the fiberglass, making it more slippery. Also, if there is any algae or other build-up on the steps, it can make them more slippery.
How do you fix a pool step?
Assuming you are referring to a vinyl pool step:
1. Remove the screws from the vinyl pool step, using a power drill.
2. Pry off the vinyl pool step with a putty knife.
3. Cut a new piece of vinyl pool step to fit the opening, using a utility knife.
4. Apply a bead of silicone caulk around the edge of the opening.
5. Place the new vinyl pool step in the opening and press it into the bead of caulk.
6. Drill pilot holes through the vinyl pool step and into the underlying wood.
7. Screw the vinyl pool step into place with the power drill.
8. Caulk around the outside edge of the step with silicone caulk.